Microtest TSB-67 - 568A Annex E - Manual (Page 7)

Page 7
Status Slow Blink Battery is low
Charging Steady Light The Injector is inactive, the AC adapter is present
and the battery pack is being charged at the maximum rate.
Charging Off The Injector is inactive and the battery or AC adapter is
not present; or the Injector is active.
Charging Blinking (once The Injector is inactive and the AC adapter is present; the
every 10 battery pack is fully charged and the Injector is in trickle
seconds charge mode.
Circuit Blinking Overvoltage condition
Guard,
Pass, Fail,
plus steady
tone
Super Injector+/Super Injector LED Indicators
Indicator State Description
Status Rapid blink Test in progress
Status Steady light Injector waiting for
signal from Scanner
Status
Slow blink Injector battery low
Pass Steady light Test has passed
Fail Steady light Test has failed
Fail, plus Steady light Overvoltage steady
tone condition
When to Use the Injector
Some measurements require the use of the Injector at the far end of the cable. For other
measurements, the Injector can be connected but its use is optional. The Scanner automatically
detects the presence of and configures the Injector for the measurement to be performed. The
following table outlines when to use the Injector:
Test Connector
(36-pin on Super
Injector+ or Mod 8
on Super Injector)
Pass
Indicator
Fail
Indicator
Status
Indicator