Impulse noise test results, Peak-to-peak noise test results – Microtest TSB-67 - 568A Annex E User Manual
Page 61
Page 61
If
OVR
(Overrange) is displayed, the Capacitance is greater than can be measured or the cable is
properly connected.
Press the
ESCAPE
key to exit.
Impulse Noise Test Results
To display the
IMPULSE NOISE
screen, from the
Ready
screen, press
Jack (F4)
and set the Jack
to Coax. Then press the
Measure Cable Performance
key, then select
Impulse Noise
.
During the Noise test, the cable can be open, shorted or terminated. There is no preference.
Press
Clear (F2)
to clear the graph.
Press
Level (F4)
to change the voltage level for detecting impulses.
Press the
ESCAPE
key to exit.
Peak-to-Peak Noise Test Results
To display the
PEAK-TO-PEAK NOISE
screen, from the
Ready
screen, press
Jack (F4)
and set
the Jack to Coax. Then press the
Measure Cable Performance
key, then select
P-P Noise
.
During the Noise test, the cable can be open, shorted or terminated. There is no preference.
Press the
ESCAPE
key to exit.
4747 North 22nd Street Phoenix, AZ 85016-4708
(602) 952-6400 FAX (602) 952-6401
Microtest Europe
2A Kingfisher House, Northwood Park, Gatwick Road
Crawley, West Sussex, RH102XN, United Kingdom
+44 1293 894000, FAX +44 1293 894008
http://www.microtest.com
Part Number 2938-4509-03E Rev 1 3/96