Mercedes-Benz 2006 CL 500 - Manual (Page 199)

198
Controls in detail
Power windows
̈ Switch on the ignition ( ୴ page 34).
Opening the power windows
̈ Press switch 1 to 4 at the
symbol k to the resistance point.
The corresponding window will move
downwards until you release the
switch.
Closing the power windows
̈ Press switch 1 to 4 at the
symbol j to the resistance point.
The corresponding window will move
upwards until you release the switch.
Fully opening the power windows
(Express-open)
̈ Press switch 1 to 4 at the
symbol k past the resistance point
and release.
The corresponding window opens com-
pletely.
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle.
Do not leave children unattended in the ve-
hicle, or with access to an unlocked vehicle.
Unsupervised use of vehicle equipment may
cause an accident and/or serious personal
injury.
i
You can also open or close the side
windows and power tilt/sliding sunroof
using the SmartKey or SmartKey with
KEYLESS-GO*, see “Summer opening
feature” (
୴ page 200) and
“Convenience closing feature”
(
୴ page 200).
Depending on current position, the win-
dows may also open or close when the
air recirculation button
, or the
charcoal filter button e in the
climate control panel ( ୴ page 185) is
pressed and held.
i
Operating the rear side windows from
the rear is not possible if you activate
the override switch (
୴ page 78).
i
With the SmartKey in starter switch po-
sition 0 or removed from the starter
switch, the door windows can be oper-
ated:
ț until you open the driver’s or pas-
senger door
ț for at least 5 minutes
Warning!
G
If you press and hold the switch up when
closing a door window, and upward move-
ment of the window is blocked by some ob-
struction including but not limited to arms,
hands, fingers, etc., the automatic reversal
will not operate.
୴୴