Muratec MFX-1500 - Manual (Page 47)

Getting started
1.38
Directly entering a rate
Using the numeric keypad, directly enter the reduction or enlargement rate by doing
one of the following.
Either . . .
1. Press #.
2. Enter your desired rate using the numeric keypad. You can set any rate from
50% reduction through 200% enlargement.
3. Press # again.
. . . or . . .
Press or to adjust the rate, at 1% intervals, from/including 50% reduction
through 200% enlargement.
Copy protection
With such a versatile copier built right into your fax machine, you might want to
make sure it doesn’t become too tempting to some people whose unauthorised
copying could deplete your machine’s supplies more rapidly. So, to limit the use of
your fax machine to only sending and receiving faxes — in other words, to activate
copy protection:
1. If the machine is in Fax mode, skip to step 2.
Otherwise, press
COPY / FAX to change to Fax mode.
2. Press PROGRAM , J , 0, 3, ENTER .
Copy Protect: Off
Program/Enter
3. Press PROGRAM to turn on copy protection.
Copy Protect: On
Program/Enter
4. Press ENTER .
Copy Protect
** Complete **
While this setting is active, whenever someone tries to change the machine to Copy
mode, the machine will sound a brief alarm tone and display:
Fax Ready
Copy Off
Important: To turn off copy protection off so that you can again use the machine’s
copying function, repeat steps 2–4, above (step 1 is unnecessary since
the machine will be in Fax mode) except that, in step 3, you press
PROGRAM so that the display shows:
Copy Protect: Off
Program/Enter