Muratec MFX-1500 User Manual
Page 113
Beyond the basics
2.65
2.
Select the key in which you want to program a command or change a
previously stored command — if necessary, turn the fliptab to see it, as
described earlier — and then press it. Here, we’ve selected 77.
Select Program No.
77:No Number Stored
3.
If you change your mind and wish to select a different programmable one-
touch key, go back to step 2 before going on to step 4.
4.
Press
ENTER
. The display now shows either:
77:Fax Number
_
or
77:Fax Number
9-5558743
5.
Use the numeric keypad to enter the “hub” machine’s number exactly as your
machine should dial it, including whatever codes your phone system may
require. The number can be up to 40 characters in length:
77:Fax Number
9-5550629_
Your display can show only 20 characters at a time. To view characters beyond
those 20 (such as with an international long-distance numbers), press
to
scroll leftward or
to scroll rightward.
Important:
Do not press
ENTER
.
Note:
If you make a mistake or want to erase characters entered in a previous
setting, press
CANCEL
to erase leftward. Or, if you want to change just
one character in the number, press
to move the cursor leftward, or
to move it rightward, to that character and press
CANCEL
to erase it.
Then re-enter until the number is just as you want it.
6.
Now, while you still can see the fax number on the display, press
COMMUNICATION OPTIONS
three times and then press
ENTER
.
The display shows:
Relay Tx
Group No. _
7.
Use the numeric keypad to enter the two-digit identifier (01–32) for the first
call group. You can specify up to 10 separate groups for each relay broadcast
initiation; between the entry of each new group, press
GROUP DIAL
to insert a
comma but do not insert a comma after the last group number. For example,
here, we’ve entered 0, 4,
GROUP DIAL
, 1, 1,
GROUP DIAL
, 2, 4:
Relay Tx
Group No. 1,24_
Note:
The display shows only four characters of the group number.
Important:
Again, do not insert a comma after the last group number.
When the entry is complete, press
ENTER
.
8.
If you want the transmission to begin immediately every time you press the
key, press
ENTER
again and skip to step 11.
If you want to delay the transmission (perhaps to take advantage of lower
phone rates), press
COMMUNICATION OPTIONS
,
ENTER
.
9.
There’s a choice to make. Instruct your fax to carry out this delayed command
in one of the following ways:
Option 1:
Perform the command once at a certain time on a certain day of
the month (For example, “Do this at 5:05
PM
on the 30th.”)
To select this option, use the numeric keypad to enter the date and
time when the fax should perform the command:
Delayed
Enter Time: 30/17:05
Option 2:
Perform the command at a certain time each day you press the key.
(For example, “Do this at 5:05
PM
today.”)
To select this option, use the numeric keypad to enter 0, 0 (i. e.,
00), and then the time when the fax could perform the command:
Delayed
Enter Time: 00/17:05
10.
Press
ENTER
,
ENTER
.
11.
The display now shows the next programmable one-touch key.
If you do not wish to enter or change any other key’s programming, press
STOP
to return your machine to its usual standby mode.
If you do wish to enter or change this key’s programming, go back to step 3.
If you wish to enter or change another key’s programming, go back to step 2.