Muratec MFX-1500 - Manual (Page 119)

Beyond the basics
2.71
Programmable one - touch fax dialling
To dial a fax call using a programmable one-touch number:
1. If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
COPY / FAX to change to Fax mode.
2. Insert the document.
3. Adjust resolution and contrast if necessary.
4. Toggle between transmission from the feeder or from memory if necessary, by
pressing
MEMORY TRANSMIT .
Note: This toggle affects only a transmission from the ADF . Transmission
from the FBS is always memory transmission.
5. Press the programmable one-touch key in which you’ve stored the number.
The machine will handle the call from here, performing the operation you’ve
programmed either now or later, depending on what you specified.
Note: To review the details of each available operation, please review its
appropriate area in these instructions. See page 2.61 for a list of where
you may find each operation.
If you programmed this key to delay its operation, the display will show:
** Reserved **
A4 Mem95%
However, if you programmed this key to perform the operation immediately
after the keypress, the display will show the number:
9-1-972-555-4335
A4 Mem95%
Erasing a programmable one - touch key
1. If the machine is in Fax mode, proceed to step 2.
If it is in Copy mode, press
COPY / FAX to change to Fax mode.
2. Change to the Fax mode then press PROGRAM , C , 2, ENTER . The display
shows something like:
Select Program No.
73:Delayed
If 73 is the key you want to erase, skip to step 3. (However, our examples from
here will say “74” rather than “73.”)
3. Press the programmable one-touch key you want to erase. Here, we’ve
selected 74:
Select Program No.
74:Polling
4. If you change your mind and wish to erase a different programmable one-
touch key, just press that key before going on step 5.
5. Press ENTER . The display shows:
Erase P One-Touch
Check Program/Enter
Important: If you want to quit without erasing the programmable one-touch key
you’ve selected, press
PROGRAM . The fax will return to step 3.
6. Press ENTER to erase the number.
Erase P One-Touch
** Complete **
To erase another programmable one-touch key, repeat steps 3–5.
Or press
STOP to return to standby mode.
Printing a list of your programmable
one
- touch keys
Your fax machine can print a list of the commands you’ve stored in your
programmable one-touch keys. The list includes each key’s one-touch letter, the
telephone number, when the command should start, which command you’ve selected
and — if applicable — the selected call group(s), SecureMail mailbox(es) or database
file(s) you’ve stored in the key.
To print the list, change to the Fax mode then press PROGRAM , C , 3, ENTER .