Motorola MBP15 - Manual (Page 7)

Getting started 7
ENG
L
ISH
2. Getting started
2.1 Baby unit battery Installation
The baby unit can be used either with 3 AA size batteries (non-
rechargeable batteries recommended) or the household AC mains. The
baby unit has no charging function!
IMPORTANT
The non-rechargeable batteries for the Baby unit are not supplied with
your product. We recommend the batteries to be installed before use, so
that the unit continues to work in the event of a mains power failure.
1. Using a screwdriver, turn the screw of the battery cover on the back
of the baby unit 90 degrees in a counterclockwise direction. Remove
the battery cover.
NOTE
Do not try to rotate the screw further than the position
OPEN .
2. Install 3 AA non-rechargeable batteries following the polarity as shown.
3. Close the battery compartment and turn the screw 90 degrees back
in a clockwise direction.
4. Press
P
. The power LED will illuminate.
5. Press and hold
P
to switch off the baby unit.
NOTE
When the battery level is low, the power LED flashes.
WARNING
Do not mix old batteries with new ones.
Keep batteries away from small children.
Do not short-circuit batteries or dispose of in fire.
Remove the batteries if this device is not going to be used for a long
period of time.
90° MAX
+
+ +
-
xA
A
1
+
-
A A x 1
+
-
AA x 1
+
-
xA
A
1
-
A
A
x
1
+
AA
x
1