Motorola MBP15 - Manual (Page 11)

Getting started 11
ENG
L
ISH
2.6 Registration
The baby monitor is already pre-registered upon your purchase. You do
not need to re-register it again unless the baby unit loses its link with the
parent unit.
To re-register your baby monitor, follow the procedure below:
1. Switch off the baby unit mains power and remove the small power
plug from the baby unit. Then, remove the batteries from the parent
unit.
2. Press and hold
P
while the baby unit mains power is switched
back on, and keep holding it down until the night light flashes. The
baby unit is in registration mode.
3. Press and hold
P
while the batteries are replaced in the parent
unit, and keep holding it down until the red sound LEDs flash. The
parent unit is in registration mode.
4. Wait for the 2 units to search and establish the link.
When the registration is complete, the LEDs stop flashing and the parent
unit emits a long beep.
2.7 Paging
If the parent unit is misplaced, press
3
on the baby unit.
The parent unit will emit a repeated beep tone for 30 seconds so that you
can locate it.
Press any key on the parent unit to stop paging.