Product features, Code approval – Monessen Hearth Direct Vent BLDV400 User Manual
Page 5

74D0009
5
PRODUCT FEATURES
AND
CODE APPROVAL
Off/Pilot/On Knob
Figure 1 - BLDV Series Fireplace
• This appliance has been certified for use
with either natural or propane gas. See
appropriate data plates.
• This appliance is not for use with solid
fuels.
• The appliance is approved for bedroom
or bedsitting room installations.
• The appliance must be installed in accor-
dance with local codes if any. If none exist
use the current installation code. ANSI
Z223.1/NFPA 54 in the USA, CAN/CGA
B149 in Canada.
• This appliance is mobile home appr-
oved.
• The appliance must be properly con-
nected to a venting system.
• The appliance is not approved for closet
or recessed installations.
Hi/Lo Knob
PRODUCT SPECIFICATIONS
The efficiency rating of this appli-
ance is a product thermal efficiency
rating determined under continuous
operating conditions and was deter-
mined independently of any installed
system.
Thermal Efficiency = up to 80%
CODE APPROVAL
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT VENT GAS
FIREPLACE HEATERS in the USA and Canada as follows:
LISTED VENTED GAS FIREPLACE HEATER
TESTED TO: ANSI Z21.88-2005/CSA 2.33-2005 STANDARDS
A manufactured home (USA only) or mobile home OEM installation must conform with the Manufactured Home Con-
struction and Safety Standard, Title 24 CFR, Part 3280, or when such a standard is not applicable, the Standard for
Manufactured Home Installations, ANSI/NCSBCS A225.1, or Standard for Gas Equipped Recreational Vehicles and
Mobile Housing, CSA Z240.4.
On/Off/RS Switch
Ignitor