Manitowoc Ice Q290 - Manual (Page 26)

Maintenance Section 4
Re-Installing the Paddle Wheel Guard
1
When re-assembling the rocking chute/door, the
paddle wheel guard is placed in the slot in the ice
chute.
Notice that a cylinder hinge is welded to the top
front side of the paddle wheel guard, as shown in
the picture above.
When the paddle wheel guard is placed in the slot
in the ice chute, the cylinder hinge on the front of
the paddle wheel guard faces forward, as shown
in the picture above.
When the paddle wheel guard is correctly
installed, the paddle wheel guard will swing
outward toward the front of the chute, allowing
ice to flow out of the chute.
If incorrectly installed, the paddle wheel guard
will not swing outward and ice delivery is
blocked.
Cylinder
hinge
Welded to
Front of
Paddle wheel
Guard
Correct Installation
Slot in
Chute
Paddle
wheel
guard
Paddle
wheel
guard
(front)
2
Correct Installation:
If you press your finger forward against the
paddle wheel guard, the paddle wheel guard does
not swing back open.
Incorrect Installation
Paddle
wheel
guard
3
Incorrect Installation:
If you press your finger forward against the
paddle wheel guard, the paddle wheel guard does
swing back open.
4-6