Manitowoc Ice Q290 - Manual (Page 15)

2-3
Section 2 Installation
Installation Procedures
WARNING
Do not attempt to move a dispenser without first
removing the ice machine. The combination can be
unstable and could tip, causing serious injury.
1. Review the installation Check List then make sure
all utility and space requirements are present at the
installation site.
2. Remove the carton top from the dispenser.
3. Remove the legs and other accessories from inside
the dispenser bin.
4. Remove the carton from the sides of the dispenser.
5. Remove the dispenser from the shipping pallet.
6. Flatten the shipping carton.
7. Lay the dispenser on it back on the carton.
8. Thread the legs into the bottom of the dispenser.
9. Set the dispenser upright.
10. Place the dispenser in the desired location.
11. Make sure the dispenser bin top is level. A level bin
is important for proper operation of the ice machine.
12. Place the ice machine on top of the dispenser at this
time.
13. Connect the drain of the dispenser to the floor drain.
Vent the drain at the back of the dispenser to reduce
buildup of algae and improve drainage.
14. Follow local plumbing codes for drain installation.
15. If the dispenser has a water valve, connect your
water line to the water connection at the back of the
dispenser.
16. Test all drain and water lines for leaks.
17. Plug the dispenser into the proper electrical outlet.
18. Clean and sanitize all equipment. Follow cleaning
and sanitizing instructions in this manual.
19. Adjust the ice machine according to the
instructions provided with the ice machine.
20. Install ice baffle inside the ice maker
compartment. Follow installation instructions
supplied with ice baffle.
21. Install foam gasket on the bottom of the front
panel.
22. Fill the dispenser bin one quarter full of ice or start
the ice machine, allowing the ice machine to drop
at least three complete batches of ice.
23. Test the ice dispensing action of the dispenser