Monessen Hearth IDV SERIES IDV380NVC - Manual (Page 26)

6 57D0016
IDV380/IDV490 Fireplace Insert OPeRAtiNG iNStRuCtiONS
PILOT
OF
F
PILOT
O
N
Figure 36 -
Off Position
OF
F
PILO
T
ON
PILOT
FP1937
control knob on
PILOT
OF
F
PI
LO
T
ON
ON
OFF
FP1939
fan control knob
liGhtiNG BuRNeR
MAiN BuRNeR SWitCh
The “ON/OFF” switch for the main burner can be found on the right side of insert surround. This
switch allows you to turn on and to turn off the main burner without using the gas valve knob.
Make sure the button is in the “ON” position to light the main burner. Figure 33
liGhtiNG the BuRNeR
Depress and turn the knob counterclockwise
to the “ON” position. Figure 34. It will take less
than four (4) seconds for the burner to ignite.
PilOt POSitiON
Depress and turn knob to pilot position to keep burner off while maintaining the pilot light. Figure
35
Depress and turn knob clockwise to “OFF”
position. Figure 36
tO tuRN OFF GAS
ADjuStiNG BlOWeR SPeeD
The internal blower helps transfer heat from heater into room.
It will not turn on until heater is up to temperature (approxi-
mately 10 minutes after starting).
To turn blower off, turn knob all the way counterclockwise
. One click clockwise turns blower to high speed.
Turning knob clockwise from high position decreases
speed of blower. Figure 37
Figure 37 -
Blower Knob
Figure 34 - On Position Figure 35 - Pilot Position Figure 33 -
On/Off Switch