Monessen Hearth IDV SERIES IDV380NVC - Manual (Page 19)

57D0016
IDV380/IDV490 Fireplace Insert
19
lOG PlACeMeNt
Before you begin - This unit is supplied with seven (7) ceramic fiber logs. Do not handle these logs with
your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling
the logs, wash your hands gently with soap and water to remove any traces of fibers.
W
ARN
iNG
the positioning of the logs is critical to the safe and clean operation of this heater. Sooting and
other problems may result if the logs are not properly and firmly positioned in the appliance.
Never add additional logs or embellishments such as pine cones or vermiculite to the heater.
Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts specifically
approved for this heater may result in property damage or personal injury.
iNStAlliNG lOGS AND ROCK WOOl (eMBeR MAteRiAl) iN FiReBOx
1. Open front door of firebox.
. Break up rock wool (ember material) into dime-sized pieces. Place evenly as shown. Do not exceed
1" layer. Refer to Figure 18
LG765
place rockwool
Rockwool
Areas
LG765
LG766
rockwool
LG766
Figure 18 -
Rockwool Placement
LG767
Rear log #1
Rear Log
#1
LG767
Figure 19
3. Carefully remove the seven (7) logs
from wrapping.
4. Place rear log #1 against back of
firebox. Figure 20