GE GXRV10ABL01 - Manual (Page 16)

Faucet Drain Tubing and Water Supply Tubing
If Option A, BASEMENT ACCESS INSTALLATION, see
Filtration Drain Connection Installations section,
was used, go to step 2.
If Option B, C or D from page 13 or 14 was used,
connect the faucet drain tubing by running the 27
″
length, 3/8
″ tubing from the 3/8″ faucet barb to the
drain fitting (installed in Filtration Drain Connection
Installations section). Keep this tubing run as short
and straight as possible, without loops, dips or
low-spots.
Cut the tubing as needed and insert
into the drain fitting (see Fig. 3B, 3C or 3D in the
Filtration Drain Connection Installations section).
To connect the water supply tubing: Run the 1/4
″
tubing (marked “WATER SUPPLY”) from the
Reverse Osmosis inlet to the feed water supply fitting
(see Fig. 2A or 2B, in the Feed Water Supply section).
Connect the tubing as applies (Fig. 2A or 2B, in the
Feed Water Supply section) and tighten the nut
securely (use Teflon Tape
TM to prevent leaks).
Apply the Filter replacement reminder label to
one of the filter sumps between the ribs. Mark the
date for filter replacement six months from the
installation date. 3
2
1
Fig. 5.
3/8 ″
drain tubing
Drain line*
Water supply valve or
compression fitting
Hot Cold
Automatic shutoff assembly
Storage tank
* For drain line options see Filtration Drain Connection
Installations section.
RO inlet
Filter Replacement
Reminder Label
16
Step-by-step installation instructions.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions Installation Instructions