GE GXRV10ABL01 - Manual (Page 10)

• Battery Powered Cordless Drill
• 1/4
″ Drill Bit
• 1-1/4 ″ Drill Bit (type as required) if mounting is needed for faucet
• Adjustable Open-End Wrenches
• Phillips and Straight Screwdrivers
• Utility Knife
• Contents Included with the Product:
— Reverse Osmosis Assembly
— Product Literature (Owner’s Manual and Installation, Use and Care Video,
Performance Data Sheet and Owner Registration Card)
— Water Supply Valve Parts Bag
— Drain Line Adapter
— 27
″ Length of 3/8″ Tubing
— Storage Tank
— Filter Replacement Reminder Label
— Water Test Kit
INSTALLER RESPONSIBILITY: The water supply valve (see the Feed Water Supply section) is
included for use in areas where codes permit. Installer must comply with state and/or local codes.
If not, the installer must provide fittings to tap the cold water pipe for a feed water source to the
Reverse Osmosis system (must adapt to 1/4
″ OD tubing).
Installation instructions.
Important Installation Recommendations
Read entire manual. Failure to follow all guides and rules could cause personal injury or
property damage.
• BE SURE TO FOLLOW ALL APPLICABLE STATE AND LOCAL CODES.
• Use a qualified installer.
• Do not install the Reverse Osmosis system outside or in extreme hot or cold temperatures.
DO NOT INSTALL ON HOT WATER.
• Recommended installation is under the sink. However, the unit can be installed in a remote
location, up to 30 feet away from the sink. Additional installation materials may be required.
• If Reverse Osmosis system is connected to a refrigerator icemaker, a special icemaker connection
kit is required (RVKIT). Do not use copper tubing for the connection between the Reverse
Osmosis system and the refrigerator.
• Be sure the water supply conforms to the specifications; see the Specifications Guidelines section.
If water supply conditions are unknown, contact your municipal water company or your local
health department for a list of contaminants in your area and a list of laboratories certified by
your state to analyze drinking water.
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts. This system shall only be used for arsenic reduction
on chlorinated water supplies containing detectable residual-free chlorine at the system inlet. Water
systems using an in-line chlorinator should provide a one minute chlorine contact time before the RO
system.This Reverse Osmosis system contains a replaceable treatment membrane cartridge critical for
effective reduction of Total Dissolved Solids. The water should be tested periodically to verify that the
system is performing satisfactorily. This system is acceptable for treatment of influent concentrations
of no more than 27 mg/L nitrate and 3 mg/L nitrite in combination measured as N and is certified for
nitrate/nitrite reduction only for water supplies with a pressure of 280kPa (40 psig) or greater.
Small parts remaining after the installation could be a choke hazard. Discard safely.
Tools and Materials Required for Installation
10
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions