Grizzly G0632 - Manual (Page 33)

G0632 16" x 42" Variable Speed Wood Lathe
-31-
Spindle Turning Safety Tips:
• When turning the lathe ON, stand away from
the path of the spinning workpiece until the
lathe reaches full speed and you can verify
that the lathe will not throw the workpiece.
• Use the slowest speed when starting or stop-
ping the lathe.
• Select the right speed for the size of workpiece
that you are turning:
—Use the slower speeds for large workpieces
(diameters of 4" and over) and for rough
cutting.
—Use the middle range speeds for workpiece
diameters of 2–4".
—Use the faster speeds for workpieces under
2".
• Keep the turning tool on the tool rest the
ENTIRE time that it is in contact with the
workpiece.
• Learn the correct techniques for each tool
you will use. If you are unsure about how to
use the lathe tools, read books or magazines
about lathe techniques and seek training
from experienced and knowledgeable lathe
users.
Keep the lathe tool resting on the tool
rest the ENTIRE time that it is in contact
with workpiece or when preparing to make
contact between lathe tool and workpiece.
Otherwise, the spinning workpiece could
force the lathe tool out of your hands or
entangle your hands with the workpiece.
Failure to heed this warning could result in
serious personal injury.
11. Position the tool rest approximately 1 ⁄
4
" away
from the workpiece and approximately 1 ⁄
8
"
above the workpiece center line (see Figure
42).
���������
�����������
���������
���������
� �
�
�
� �
�
�
Figure 42. Tool rest position relative to
workpiece.
12. Before beginning lathe operation, rotate the
workpiece by hand to ensure that there is
safe clearance on all sides.
Tool Rest