Garland 200 - Manual (Page 18)

Page 18 Part # MCOSM06 Rev 1 (11/03/08)
1. Press and hold PROG key for three (3) seconds - all the
product key LEDs light.
2. CODE will be displayed. The controller is asking for the
access code. Press 4-2-7-5 and the START/CANCEL key.
PROD will be displayed indicating you have gained access
to Product Programming.
3. Press the product key (1 - 9) into which you want to store
a cooking program. SHLF will be displayed. The control is
asking if you want to program the key as a shelf timer or
with a cooking profile. Select your answer by pressing the
START/CANCEL key. When the correct answer is displayed,
press the SET key. The TIME LED will light. 30:00 will be
displayed.
4. Set first cook time using dial. If more than one cooking
profile is desired:
• press the product key where the program is to be stored
(1 - 9) - PR-2 will be displayed.
• set the second cook time using the dial (factory presets
for PR-2 through PR-5 are :00).
• press the same product key (1 - 9) again - PR-3 will be
displayed.
• Repeat this process for all profiles. When the last profile
time has been entered, press the SET key, OR
If less than five (5) profiles are desired press the SET key
after the last required profile - PRE will be displayed,
followed by :00. The controller is asking if you would like a
reminder alarm (pre-alarm) to sound during the cooking
process. (factory preset is :00).
5. If a pre-alarm signal is desired - dial in the time that the
alarm is to sound. (Ex. If the product is to be turned
halfway through the 60 minute cooking cycle, set the
pre-alarm to 30 minutes). If pre-alarm is not desired verify
that ":00" is displayed. Press the SET key - TEMP Led will
light, and the display will show the first profile cooking
temperature. (factory preset at 350°F).
6. Set the first cooking temperature using the dial.
Press the product key - PR-2 will be displayed followed by
the second temperature.
Set the second cooking time using the dial.
Repeat as you did for cooking time, for all the profiles
desired.
NOTE: The controller will only accept cooking temperatures
for the number of profiles for which a cooking time
has been set. If the product key is pressed after the
last programmed profile, the first temperature will be
displayed.