Grizzly G0493 - Manual (Page 51)

Model g0493 (Mfg. since 7/10)
-49-
figure 95. example of miter cutting operation.
the crosscut fence allows miter cuts from 0˚
through 135˚. the table mounted miter scale has
a resolution of 1˚.
to perform a miter cut:
1. slide the crosscut table to the front edge of
the sliding table and lock it in place.
2. place the crosscut fence center stud in the
center stud hole of the crosscut table. the
fence can be installed as shown in
figure 94
for 90˚ to 135˚ cuts, or as shown in figure 95
for 0˚ to 90˚ cuts.
miter cutting
3. rotate the fence to the desired angle and use
the lock knob to lock the fence in place.
4. position the flip stop according to the length
of the workpiece you want to cut off to the left
of the blade.
5. load the workpiece onto the table saw. the
set up should look similar to figure 95.
6. once all the necessary safety precautions
have been taken, perform the cutting opera-
tion.
figure 94. Fence set-up for 90˚ to 135˚ cuts.