Grizzly G0493 - Manual (Page 34)

-32-
Model g0493 (Mfg. since 7/10)
47. thread the M12-1.75 x 55 adjustable handle,
with a 12mm flat washer, through the cross-
cut table and into a M12-1.75 t-nut as shown
in
figure 52.
figure 52. installing the adjustable handle.
figure 51. end washer on round rail.
end Washer
42. adjust the scoring blade, using the horizontal
adjustment controls, until the rip fence evenly
touches both blades.
43. Move the rip fence against the blades again.
loosen the screws securing the scale bar,
line up the 0" mark on the scale with the left
edge of the rip fence, then tighten the scale
bar mounting screws.
44. set the rip fence to 1 ⁄
8
", slide the adjustable
ring with set screw on the round rail against
the fence housing. Without moving the ring,
move the fence housing out of the way, and
secure the set screw on the ring, as shown
in
figure 50. When installed correctly, this
ring will prevent the fence from contacting the
blade.
45. Move the blade guard back to its original
position, and move the sliding table back to
center.
46. place the end washer (figure 51) on the
end of the round rail and secure it with the
M8-1.25 x 16 cap screw and 8mm lock wash-
er.
figure 49. Fence used to align blades.
41. Move the rip fence against the main blade (or
scoring blade) as shown in figure 49.
figure 50. securing the adjustable ring.
adjustable ring
w/set screw