Grizzly G0493 - Manual (Page 29)

Model g0493 (Mfg. since 7/10)
-27-
14. loosely attach the small extension table to
the left side of the cast iron table with two
M10-1.5 x 20 cap screws, two 10mm lock
washers, and two 10mm flat washers as
shown in
figure 32. note: The cap screws
will be tightened during a later step.
figure 32. small extension table attached.
Cap screws
set screws
12. attach the table support to the saw body, as
shown in figure 31, with the cap screws and
washers already installed on the saw body.
figure 31. small extension table support cap
screws (table removed for photo clarity).
13. thread an M10-1.5 hex nut all the way onto
two M10-1.5 x 20 cap screws, then install the
cap screws where shown in
figure 31 to help
level the small extension table level once
it is installed. tighten the hex nuts against
the table support to lock the cap screws in
place.
17. thread an M10-1.5 hex nut onto each of four
M10-1.5 x 20 set screws, then thread each
of the set screws into the small holes in the
large extension table, as shown in
figure
33. Make sure the set screws do not stick out
from the mating surface.
16. loosely attach the large extension table to
the back of the cast iron table with four M10-
1.5 x 20 cap screws, four 10mm lock wash-
ers, and four 10mm flat washers, as shown
in
figure 33. note: The cap screws will be
tightened during a later step.
15. thread two M6-1 x 12 set screws into the
small holes in the small extension table.
Make sure the set screws do not stick out
from the mating surface.
figure 33. large extension table attached.
Cap screws
set screws & hex nuts
figure 34. Checking with a straightedge.
18. use a straightedge, as shown in figure 34,
to make sure the extension tables are even
with the cast iron table. use the set screws
under the extension tables to level the top
surfaces, then tighten all the mounting cap
screws.