Grizzly G0493 - Manual (Page 28)

-26-
Model g0493 (Mfg. since 7/10)
7. secure the sliding table to the cabinet with
three M12-1.75 hex nuts, three 12mm lock
washers, and three 12mm flat washers.
note: Use the access holes on each side of
the cabinet to reach the T-bolts on the ends
of the sliding table (
Figures 25 & 26). To
access the T-bolt in the center of the sliding
table, tilt the blade to 0° and reach through
the dust port (
Figure 27).
figure 25. left end access hole.
figure 26. right end access hole.
figure 27. dust port access hole to access
center t-bolt.
8. insert the end cap into the sliding table, as
shown in figure 28.
9. install the end handle, as shown in figure
29, using screws removed in step 1.
10. rotate the table lock up to unlock the slid-
ing table. the sliding table is locked in place
when in the position shown in
figure 29.
figure 29. sliding table end handle.
table lock end handle
figure 30. sliding table push handle installed.
push
handle
12mm Flat Washer
M12-1.75 t-nut
11. install the push handle into the table, as
shown in figure 30, with a 12mm flat washer
and M12-1.75 t-nut.
figure 28. installing the lock plate.
end Cap