Graco Inc. 244581 - Manual (Page 16)

Installation
16 309293K
Select a Fluid Nozzle and Air
Cap
The gun is supplied with Part No. 197266 Nozzle and
24A276 Air Cap. If you require a different size, refer to
Table 1 and Table 2 , and instruction manual 309419, or
consult with your Graco distributor. See Air Cap/Nozzle
Replacement on page 42.
A wide pattern kit (P/N 24A431) is included with the gun
and if installed, will provide fan air for wider spray pat-
terns. (If pattern becomes split, use the fan air valve to
reduce the amount of fan air.)
* Also available in the following colors:
24A276 - blue
24A277 - red
24A278 - green
WARNING
Pressurized Equipment Hazard
To reduce the risk of an injury, follow the
Pressure Relief Procedure on page 20
before removing or installing a fluid nozzle
and/or air cap.
Table 1: Fluid Nozzles
Part No.
Size,
mm (in.)
Part No.
Size,
mm (in.)
197263 0.75 (.030) 197266 1.5 (.055)
197264 1.0 (.042) 197267 1.8 (.070)
197265 1.2 (.047) 197268 2.0 (.080)
Table 2: Air Caps
Part No.
Pattern Shape
and Length in.
(mm)
Recommended Fluids and
Production Rates
24A438
Round end;
15-17 (381-432)
Light to medium viscosity.
Up to 15 oz/min (450
cc/min)
24A279
Round end;
14-16 (356-406)
Medium to high viscosity
and high solids.
Up to 15 oz/min (450
cc/min)
24A376*
Tapered end;
17-19 (432-483)
Light to medium viscosity.
Up to 15 oz/min (450
cc/min)
24A274
Tapered end;
12-14 (305-356)
Light to medium viscosity.
Up to 15 oz/min (450
cc/min)
24A439
Round end;
11-13 (279-330)
Medium to high viscosity
and high solids.
Up to 15 oz/min (450
cc/min)
For use with 2.0 mm nozzle.