Genicom LA36 - Manual (Page 83)

4-26
Using Set-Up Mode
INSTALL Options and Values
• Overprinted values are the factory settings.
I N S T A L L
Options Values Description
Specify a language to be used to print the Set-Up
menu functions and options.
ENGLISH English
DEUTSCH German
ESPANOL Spanish
FRANCAIS French
ITALIANO Italian
Specify the (auto) start timing of tear off feeding.
AUTO 1 SEC 1 second after data stops from the computer
AUTO 2 SEC 2 seconds after data stops from the computer
AUTO 3 SEC 3 seconds after data stops from the computer
AUTO 4 SEC 4 seconds after data stops from the computer
AUTO 5 SEC 5 seconds after data stops from the computer
MANUAL Feed the paper for tear-off when the Pause button is
pressed.
NO TEAR Tear off feeding is inhibited under any conditions.
Specify this setting for labels that tend to peel off
during backward feeding.
Specify the (auto) start timing of single sheet loading.
AUTO 1 SEC 1 second after a single sheet is set on the platen
AUTO 2 SEC 2 seconds after a single sheet is set on the platen
AUTO 3 SEC 3 seconds after a single sheet is set on the platen
AUTO 4 SEC 4 seconds after a single sheet is set on the platen
AUTO 5 SEC 5 seconds after a single sheet is set on the platen
MANUAL Load a single sheet when the FF/Load button is
pressed.
Enable or disable the printer status buzzer when a
fault condition occurs.
ONE One beep for a period of about 500 ms
CONTINUOUS Buzzer on until the fault condition is cleared
OFF Buzzer off under any condition
(Single Sheet
Load)