Genicom LA36 User Manual
Page 77
4-20
Using Set-Up Mode
MACRO 1
and
MACRO 2
Options
Values Description
=DEC DEFLTS=========
The following are the Set-Up options for the DEC
PPL2 protocol only.
Specify the printer ID to be given in response to DA
commands from the computer.
LA50 ID
LA120 ID
LA210 ID
TRUNCATE
Characters are received but not stored in the print
buffer.
WRAP
End-of-line wrap. Causes a Carriage Return plus a
Line Feed.
Specify whether the DSR signal is controlled by the
EOT character (DEC-423 serial interface only).
NO DISCON
EOT character is ignored.
DISCONNECT
DTR signal turns low for five seconds when the EOT
character is detected.
Specify whether the status is sent to the computer
when the printer is turned on (DEC-423 serial
interface only).
NO
Status is not sent.
YES
Status is sent.
Specify whether the ANSWERBACK message is sent
to the computer when printer is turned on.
NO
ANSWERBACK message is not sent.
YES
ANSWERBACK message is sent.
Specify whether the ANSWERBACK message is sent
to the computer when printer receives an ENQ code.
N O
ANSWERBACK message is not sent.
YES
ANSWERBACK message is sent.
(DEC Defaults)
(DEC Printer ID)
(End of Transmis-
sion Disconnect)
(Initialization
Report)
(Automatic
ANSWERBACK)
(ANSWERBACK
on ENQ)