Grizzly G8692 - Manual (Page 20)

G8692 Portable Bandsaw and Stand -19-
Figure 12. Rear blade guide bearing.
Figure 13. Quick nut.
10. Secure the blade guide bearings removed in
step 5 .
11. Replace the back cover of the bandsaw.
12. Turn the blade tension lever back to
“
TIGHT .”
Using Table Vise
To use the vise on your bandsaw table:
1. Disconnect the bandsaw from the power
source.
2. Secure the bandsaw to the stand before
inserting the material to cut. Combine the
vise can operate in two different ways,
depending on how the quick nut is posi-
tioned.
— When the quick nut pointer is positioned to
the left, the vise jaw can slide rapidly up to
the material (
Figure 13 ).
Figure 14. Vise nut.
3. When the vise has secured the workpiece
properly, connect the machine to the power
source.
— When the quick nut pointer is positioned to
the right the vise jaw will move when the
crank is turned for fine adjustment and
clamping force (
Figure 14 ).