Grizzly G8692 - Manual (Page 14)

G8692 Portable Bandsaw and Stand -13-
The work stand requires the installation of four
rubber feet to provide a stable, slip resistant
base.
To install the rubber feet to the stand:
1. Disconnect the bandsaw from the power
source.
2. Turn the bandsaw stand on its side to access
the threaded holes as shown in
Figure 3 .
3. Attach the rubber feet to the guide holes in
the stand with the four Phillips head screws
supplied with the saw.
Figure 3. Installing the rubber feet.
Portable Conversion
Figure 4. Mounting brace cap screws.
The Model G8692 can be easily converted to a
portable handheld power tool.
To convert the bandsaw for handheld use:
1. Disconnect the bandsaw from the power
source.
2. Remove the bandsaw from the work stand by
removing the mounting brace cap screws
shown in
Figure 4 .
3. Install the supplied handle to the bandsaw,
using the cap screws removed in
step 2 .
4. Make sure all the fasteners are tight to elimi-
nate movement and vibration.
cap screws
Rubber Feet
Installation