GarrettCom Magnum 20X - Manual (Page 30)

Each RPM is secured to the front of the
200X chassis with two screws. Once these
screws have been removed, the RPM can be
easily lifted out of the unit.
4. RPM Card Installation
Hold the card parallel to the bottom of the
200X, with the RPM media connector
facing the front of the unit, and the RPM
connector pins facing to the right. Secure
the RPM using the two retaining screws.
Next, align the RPM pins and the RPM Side view of RPM card
cable connector, and gently push the cable
connector onto the connector pins.
5. Chassis Cover Replacement
Replace cover on chassis and secure with the four
screws.
eu
GARRETT
PWR RX COL JAB
RPM retaining screws
Retaining screw removal
PM Retaining
Screw Hole PM Mounting
Plate
Eight (8) Pin PM
Connector PM Retaining
Screw Hole
Media
Connector
AC power
connector
RPM ribbon cables
Top view of 200X -
Insertion of RPM cards