Stop – GarrettCom Magnum 20X User Manual
Page 29
all required RPM modules and media connectors installed. There may be cases where a
different RPM connector is desired, making it necessary to exchange one RPM type for
another. The replacement procedures described inthe next two sections should only
be performed by a trained technician.
3.4.1
Exchanging RPMs in the Magnum 200X
STOP!!!
Be sure the power cord is unplugged
from the chassis before attempting to remove
and/or replace an PM card.
Failure to do so may result in damage to the unit
and will void the warranty.
1.
Chassis Cover Removal
Remove the four screws
located on the sides of the
unit (two per side). Once
removed the chassis cover is
easily lifted off the chassis
base, and the interior of the
unit is exposed.
2. RPM Cable Disconnection
Each RPM of the 200X is connected to the main
eu
Magnum 200X
GARRETT
PWR RX COL JAB
Recessed screw holes
Screw holes
Chassis cover
Removal of Magnum 200X chassis cover
AC power
connector