Grizzly G0442 - Manual (Page 42)

-40-
Model g0442/g0601 (Mfg since 3/12)
section 5: operations
do not put hands or
small objects near inlet
openings during opera-
tion. objects sucked
into the inlet will meet
with the impeller blade.
failure to heed this
warning could result in
property damage or per-
sonal injury.
general
operating the Model g0442/g0601 is simple and
straightforward. Blast gates located at each of the
machines controls the air flow from the woodwork-
ing machine to the dust collector. if a machine
is not being used, keep the blast gate closed to
maintain higher levels of efficiency throughout the
system.
damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
do not use the dust collector for any
other purpose besides collecting dust from
connected woodworking machines. a dust
collector should never be used as a shop
vacuum and is not a substitute for an air
filter system. for safest use, wear a respira-
tor and use an air cleaner in addition to the
dust collector.
remote control
the remote control for the Model g0442/g0601
is ir (infrared) rather than rF (radio frequency) to
prevent accidental startups by other common rF
items such as garage door openers.
Because this remote system is ir, the remote
control must be pointing directly at the control box
with an unobstructed line-of-sight view.
if you place the dust collector in a different room or
outside of your shop, you must mount the switch
in the shop and wire it through the wall to the dust
collector to make use of the remote control.
note: The remote control requires two "AA" batter-
ies for operation.
NOTICE
if you have never used this type of machine
or equipment before, We strongly rec-
ommend that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. regardless of the con-
tent in this section, grizzly industrial will
not be held liable for accidents caused by
lack of training.