Grizzly G0442 - Manual (Page 27)

Model g0442/g0601 (Mfg since 3/12)
-25-
19. using the forklift, lift the entire assembly
approximately 2" off the ground to gain clear-
ance for filter installation.
20. Mount the two filters to the braces with
brace gaskets between them, as shown in
figure 24, using (8) 5 ⁄
16
"-18 x 3 ⁄
4
" hex bolts
and (8) 5 ⁄
16
" fender washers.
figure 24. Canister filters mounted to the long
support braces.
rubber
gaskets
here
x 8
21. Attach one roll of 3 x 15 x 700mm foam tape
to both ends of each noise muffler, then
connect them between the outlet ports and
the canisters with the 8" flexible hoses and
clamps, as shown in
figure 25.
figure 25. noise mufflers connected between
the outlet ports and the canisters.
noise
Muffler
22. using the forklift, raise the assembly up and
attach the lower stand legs to the upper stand
legs, as shown in
figure 26, using (24) 3 ⁄
8
"-16
x 3 ⁄
4
" hex bolts, (48) 3 ⁄
8
" flat washers, and (24)
3 ⁄
8
"-16 lock nuts.
figure 26. Attaching lower legs to the initial
stand assembly.
x 24
23. Attach the casters to the bottom of the lower
collection drum, as shown in figure 27, using
the (4) 3 ⁄
8
"-16 hex nuts, (8) 3 ⁄
8
" flat washers,
and (4) 3 ⁄
8
" lock washers included in the box
with the casters.
figure 27. Casters attached to the lower
collection drum.
x 4