Stovax PR0696 - Manual (Page 6)

USER INSTRUCTIONS
COAl lAYOUT
NOTE: ThERE ARE TWO lARGE COAlS IN A SEPARATE
BAG INSIDE ThE MAIN BAG FOR USE WITh A
CURvED FRONT (SUCh AS ThE hOlYROOD AND
RIChMOND) AND NOT FOR A FlAT FRONTED FRAME.
A) FRONT ROW COAl lAYOUT USING FlAT FIRE
FRONTS
7.6 This first row marks the only difference in coal layout
between the flat fronts and curved fronts. Place one large
coal centrally on the front coal resting against the frame.
Then place three small coals either side.
See diagram 8.
8
AR1166
B) FRONT ROW COAl lAYOUT USING CURvED FIRE
FRONTS
7.7 Place three large coals resting on top of the front coal and
against the front of the frame, then place two small coals
either side of the large ones. See diagram 9
9
AR1165
C) COAl lAYOUT CONTINUED FROM FRONT ROW
7.8 Place four large coals behind the first row and one small
coal either end resting up against the side panels.
See diagram 10
6
10
AR1167
7.9 Place one small coal either side on top of the flame baffle in
each rear corner. Then place two large coals in between the
two small coals. These coals should touch the rear panel.
See diagram 11.
11
AR1168
7.10 Finally place five large coals between the second and rear
row of coals. See diagram 12.
12
AR1169
7.11 It is essential that gaps are left between the coals to maximise
the performance of the appliance.
PEBBlE lAYOUT - CURvED AND FlAT FRONTS
7.12 All ThE PEBBlES hAvE AN ID NUMBERS ON ThE
UNDERSIDE. ENSURE ThE PEBBlES ARE PlACED ONlY
IN ThEIR CORRECT POSITIONS .
7.13 Place the first row of pebbles on top of the front coal resting
against the frame front. All the numbers must be placed
face down so they cannot be seen. See diagram 13.