Stovax PR0696 - Manual (Page 15)

15
INSTAllATION INSTRUCTIONS
INSTAllATION
7.3 Place the rear panel against the rear of the box and slide
the side panels on either side of the flame baffle. Ensure they
locate in the brackets at the top of the firebox. DO NOT
SLIDE THEM ALL THE WAY BACK. See diagram 11.
11
AR1161
7.4 Locate the top panel on top of the rear and side panels.
Finally push the sides fully towards the rear panel. This will
retain the top panel. See diagram 12.
12
AR1162
7.5 Place the front coal centrally in the channel at the front of
the tray. See diagram 13. The relationship between the front
coal and flame baffle is shown in diagram 13.
13
AR1160 AR1163
COAl lAYOUT
NOTE: ThERE ARE TWO lARGE COAlS IN A SEPARATE
BAG INSIDE ThE MAIN BAG FOR USE WITh A
CURvED FRONT (SUCh AS ThE hOlYROOD AND
RIChMOND) AND NOT FOR A FlAT FRONTED FRAME.
FRONT ROW COAl lAYOUT USING FlAT FIRE FRONTS
7.6 The front row is the only difference in coal layout. Place one
large coal centrally on the front coal resting against
the frame. Then place three small coals either side.
See diagram 14.
14
AR1166
FRONT ROW COAl lAYOUT USING CURvED FIRE
FRONTS.
7.7 Place three large coals resting on top of the front coal and
against the front of the frame, then place two small coals
either side of the large ones. See diagram 15.
15
AR1165
COAl lAYOUT CONTINUED FROM FRONT ROW
7.8 Place four large coals behind the first row and one small
coal either end resting up against the side panels.
See diagram 16.
16
AR1167
7.9 Place one small coal either side on top of the flame baffle in
each rear corner. Then place two large coals in between the