Installation instructions, Installation, Arrangement of fuel bed components – Stovax PR0696 User Manual

Page 14

B) SCREW FIXING METhOD

6.8 Alternatively, this appliance can be secured back to the

fire place opening using the screws and rawl plugs provided.

Place the firebox centrally in the opening and mark the

positions of the 4 fixing holes. Drill the holes and insert the 4

rawl plugs. See diagram 7.

AR1158

6.9 Offer the firebox into the opening and ensure that the gas

supply pipe passes through the rubber seal.

6.10 Refit the burner assembly and secure the 6 pozidriv screws.

Connect the gas supply to the inlet connection on the

burner unit and tighten. It may be necessary to support the

inlet connection with another spanner whilst tightening this

joint. See diagram 8.

AR1175

6.11 Turn on the gas supply to the appliance and check for leaks.

Light the fire and check all joints on the appliance for leaks.

6.12 Remove the sealing screw from the inlet connection and

connect a suitable “U” gauge manometer. Light the fire and

turn to the maximum position, refer to the data badge and

ensure that the running pressure is correct. If the pressure

varies significantly from that on the data badge, this may

indicate a supply problem and will require immediate

attention.

6.13 Turn the appliance off, disconnect the “U” gauge and

replace the sealing screw. Relight the appliance and check

the sealing screw for leaks.

INSTAllATION INSTRUCTIONS

INSTAllATION

7. ARRANGEMENT OF FUEl BED

COMPONENTS

NOTE: CERAMIC PARTS ARE FRAGIlE. ThE SIDE AND

REAR PANElS ARE REvERSIBlE. ONE SIDE IS PlAIN, ThE

OThER SIDE IS REEDED. ASk ThE CUSTOMER WhICh

SIDE IS PREFERRED AT ThIS STAGE.

ONlY USE ThE CORRECT TYPE AND QUANTITY OF

CERAMIC COMPONENTS. POINTS 7.1 TO 7.5 ARE

COMMON TO All FUEl TYPES AND lAYOUTS.

7.1 Position the burner cover gasket on the burner skin ensuring

the holes align with the ports. Take care as the front

left-hand hole is offset compared to the others.

See diagram 9, arrow A.

AR1175

7.2 Position the flame baffle centrally on the tray and ensure the

stepped lower edge engages against the rear edge of the

burner skin. See diagram 10.

AR1159