beautypg.com

Grizzly G0459P User Manual

Page 43

background image

Model G0459/G0459P (Mfg. 7/11+)

-41-

figure 51. Conveyor belt removed from table.

Conveyor

Motor

Cover

Conveyor

Motor

Flat Washer

Flat Washer

Left Rear

Roller Bracket

Cap Screw

Cap

Screw

Cap Screws

Table

figure 50. removing conveyor motor and rear

roller bracket (not all components shown for

clarity).

20. remove the rear left roller bracket (2 cap

screws).

21. remove the rear roller.

22. remove the front left roller bracket (2 cap

screws) and the front roller.

23. remove the front right and rear roller brack-

ets (4 cap screws).

24. place the right side of the conveyor on a flat

surface, then unthread and remove the front
and rear table lift screws.

25. remove the belt. the table should look like

figure 51.

26. Measure the distance between the front right

table lift screw sprocket and the mounting
bracket. if necessary, rotate the rear shaft so
the sprocket-bracket distance is the same as
the front right table lift screw.

27. install the new belt.

28. re-install the front left and rear left table

lift screws to match the front right lift screw
height.

29. reassemble the drum sander by reversing

the disassembly steps.

30. after reassembly, adjust the drums and pres-

sure rollers to their proper settings. see

Drum

Adjustments on Page 33 and Pressure

Roller height on Page 35.

31. after you have re-installed the conveyor table,

make sure the four lower pressure roller
adjustment bolts are threaded the same dis-
tance into the roller mount brackets (

figure

34).

32. after re-installing the top cover and brace,

tighten the mounting bolts.

18. lay the conveyor table on the edge of a

workbench so the conveyor motor can hang
freely.

19. remove the conveyor motor (4 cap screws)

from the conveyor motor cover, and remove
the conveyor motor cover from left rear roller
bracket (3 cap screws and 3 flat washers).

Front
right

sprocket

Mounting

bracket

rear

lift screw