Grizzly G0459P - Manual (Page 20)

-18-
Model G0459/G0459P (Mfg. 7/11+)
SEctiON 4: OPERAtiONS
to complete a typical operation, the operator
does the following:
1. examines the workpiece to make sure it is
suitable for sanding.
2. places the workpiece on the conveyor table
under or next to the front pressure roller, and
adjusts the table height until the top surface
of the workpiece just touches the front pres-
sure roller.
3. Checks the outfeed side of the machine to
make sure the workpiece can safely pass all
the way through without interference from
other objects.
4. Wears safety glasses and a respirator.
5. starts the dust collector.
6. turns the sander ON, adjusts conveyor
speed, places the workpiece flat on the
conveyor, then lets the conveyor feed the
workpiece into the sander.
7. slowly raises the conveyor table using the
hand crank until the sandpaper begins sand-
ing the workpiece.
8. stands at the side of the sander and retrieves
the workpiece from the outfeed end.
9. stops the machine.
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual and seek additional training from expe-
rienced machine operators, and do additional
research outside of this manual by reading "how-
to" books, trade magazines, or websites.
to reduce your risk of
serious injury, read this
entire manual bEfORE
using machine.
to reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
if you are not experienced with this type
of machine, WE StRONGLy REcOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly industrial will not be held liable
for accidents caused by lack of training.