GIGABYTE GN-A11G - Manual (Page 9)

GN-A11G Wireless LAN Access Point
There are two installation methods for reference:
Method 1: Static IP address
If DHCP is not used on the network, the AP can be set up via a direct
connection to the computer.
PC (AP Manager) 192.168.1.x
192.168.1.1 (Default)
Access Point
1. You must assign a static IP address to the computer. The Subnet must be
the same for the computers and AP. For example, the default IP address of
the AP is 192.168.1.1 and the Subnet Mask is 255.255.255.0. You can enter
an IP address of 192.168.1.20 (if not assigned to other network equipments)
and an Subnet Mask of 255.255.255.0.
Note: For further instructions regarding to this step, please refer to
Appendix C, Computer Configuration.
2. Please connect APs in turns and assign a static IPs to each AP. For
example, 192.168.1.2 or 192.168.1.y. (If the IP address is 10.1.5.x, 10.1.5.y
can be assigned to your AP.)
3. Please make sure an exclusive IP for each AP.
4. After setting all APs successfully, you can use AP manager to control /
monitor all APs.
9