Grizzly G0633/G0634 - Manual (Page 49)

G0633/G0634 Jointer/Planer Combo Machine
-47-
— If the pulleys are aligned, then no adjust-
ments are necessary.
— If the pulleys are NOT aligned, perform
Steps 3 & 4.
3. Remove the V-belts (see Page 34), loosen
the set screws on the end of the cutterhead
pulley, and align the cutterhead pulley with the
motor pulley.
4. Tighten the set screws, replace the V-belts,
and repeat Step 2.
5. Reinstall the V-belt cover, fence bracket and
fence assembly.
Figure 69. Pulleys properly aligned. V-belts are
parallel and coplaner.
����������
����������
������
�����
������ �����
���������
����������
The fence stops simplify the task of adjusting the
fence to 45˚ and 90˚.
Tools Needed Qty
45° Square ........................................................ 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Wrench 10mm ................................................... 1
To set the 90˚ fence stop:
1. Loosen the lock nut on the 90° fence stop bolt
shown in Figure 70, and loosen the fence tilt
lock.
2. Place a 90° square against the table and
fence, and adust the stop bolt, so the fence
is set exactly at 90°.
Setting Fence Stops
3. Tighten the lock nut.
4. Adjust the indicator (if necessary) to 0° to
calibrate the fence tilt scale.
Figure 70. Adjusting fence to 90˚.
Lock Nut
90˚Stop Bolt