GE 4 Series - Manual (Page 44)

Concord 4 Series Security Systems 34
Source information is shown in the following table.
Using a
Touchtone
Phone to
Operate Your
System
Your system may be equipped with an option that allows system operation from a Touchtone
phone, on or off the premises.
This option enables programmed text to be spoken through the phone and/or broadcast through
interior speakers. Except for custom words, the voice speaks the text that appears on alphanu-
meric touchpads in the system.
Phone Command Prefix
What distinguishes a call to the panel from any other out-going or incoming call is the use of the
Phone Command Prefix:
• In the case of on-site operation, if the Phone Command Prefix is dialed first (within 5 seconds
of picking up the phone), the panel waits for a valid access code or command.
• If the system is being accessed remotely, the Phone Command Prefix is used in conjunction
with the access code.
The prefix is usually # , but can be changed to * by the installer. If your prefix has been changed,
use * as the first key you press instead of # .
Accessing the System from Off-site
To access the system from off-site, the system needs to recognize two things about the call:
• The panel needs to recognize that it should answer the phone.
• The panel needs to recognize that the code entered has the authority to operate the system
from off-site.
U600 - U829 Regular User Codes 000 - 229
U830 - U835 Partition Master Codes 1 - 6
U838 - U843 Partition Duress Codes 1 - 6
U846 System Master Code
U847 Installer Code
U848 Dealer Code
U849 AVM Code
U850 Quick Arming
U851 Keyswitch Arming
U852 System
Detail Screen Display Source
S00 Premise Phone
S01 Phone During Conversation
S02 Remote Phone
S06 Auto Stay Arming
S07 Automation Module
S08 Keyswitch Arming Zone
S09 System
S1xx (xx = Zone Number) Keychain Touchpad
S1xx (xx = Zone Number) Wireless Touchpad
S3xx (xx = Bus Unit Number) Alphanumeric Touchpad
S6xx (xx = Bus Unit Number) Fixed Display Touchpad
Detail Screen Display User