GE 4 Series - Manual (Page 28)

Concord 4 Series Security Systems 18
Temperature settings can range from 45° to 90° Fahrenheit.
Figure 5.Energy Saver Setpoints
To set the Energy Saver temperature range from a touchpad:
1. Enter the programming menus by pressing 9 + System or Partition Master CODE .
2. Press 070 .
3. Enter the lowest temperature (45–89°F) you’ll allow before the furnace turns on, and press # .
4. Press B . Enter the highest temperature (46–90°F) you’ll allow before the air conditioner turns
on, then press # .
5. Press * + 00 + # to exit the programming menus.
Note
Disarming the system turns
off the Energy Saver.
To override your normal heating or air conditioning settings, turn the Energy Saver feature on.
When you are ready to return to your normal temperature control settings, turn Energy Saver off.
To turn Energy Saver on/off from any touchpad:
1. Press 7 + 2 . Alphanumeric touchpads display, “ENERGY SAVER IS ON,” for example.
Notification by
Pager
Your system can notify up to five different pager phone numbers to report system events. The
installer can program any numeric pager to receive pages for one or more of the following
groups.
H i g h
S e t p o i n t
9 0 °
L o w
S e t p o i n t
4 5 °
I f r o o m t e m p e r a t u r e
r e a c h e s l o w s e t p o i n t ,
f u r n a c e t u r n s o n .
I f r o o m t e m p e r a t u r e
r e a c h e s h i g h s e t p o i n t ,
a i r c o n d i t i o n e r t u r n s o n .
High Level Reports Low Level Reports
Sensor Alarms Freeze Alarms Bypass Sensors AC Power Failure
Tamper Freeze Troubles Low Battery CPU Low Battery
Restorals No Activity Alarm Supervisory Auto Phone Test
Phone Tests Fire Panic Trouble CPU Back in Service
Receiver Failure Police Panic Phone Test Phone Failure
Receiver Jam Auxiliary Panic Event Buffer Full Touchpad Low Battery
Touchpad Tamper
Bus Failures
• Opening and Closing Reports
• Latchkey Reports
• Notify by Exception Reports