GE C2S980 - Manual (Page 52)

52
Install the Anti-Tip Device
An Anti-Tip bracket is supplied with
instructions for installation in a variety
of locations. The instructions include
all necessary information to complete the
installation. Read the Safety Instructions
and the instructions that fit your situation
before beginning installation.
WARNING:
■ Range must be secured by Anti-Tip bracket
supplied.
■ See instructions to install (supplied with bracket).
■ Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury might result from spilled hot liquids
or from the range itself.
Typical installation of anti-tip bracket attachment to wall.
Bracket
Screw
must enter
wood
Wall
plate
When All Hookups Are Completed:
MAKE SURE ALL CONTROLS ARE LEFT IN THE
OFF POSITION. MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
Converting to LP Gas (or converting back to natural gas from LP)
This range leaves the factory set for use with natural
gas. If you want to convert to LP gas, the conversion
must be performed by a qualified LP gas installer. The conversion instructions and LP orifices can
be found attached to the range next to the
pressure regulator.
Keep these instructions and the orifices in case
you want to convert back to natural gas.
Installation of the range.
Operating
Instructions
Safety
Instructions
Installation Instructions
Tr
oubleshooting
Tips
Consumer
S
uppor
t