GE 164D2966P126 - Manual (Page 7)

OVEN CONTROL, CLOCK
To Set Clock
must be set for the automatic oven timing
functions to work properly. The time of day cannot be
changed during a Timed Baking or Self-Cleaning cycle.
1. Press the CLOCK pad.
CLOCK
A
2. Press the INCREASE or DECREASE
pad to set the time of day.
3. Press the CLOCK pad to start.
To Set the Timer
timer does not control oven
❑
1. Press the TIMER
operations. The maximum setting TIMER ON/OFF pad.
on the timer is 9 hours and 55 ON/OFF
minutes. A
2. Press the
INCREASE or
DECREASE pad to
set the amount of
time on the timer.
The timer will start automatically
within a few seconds of releasing the
INCREASE or DECREASE pad. The
timer, as you are setting it, will display
seconds until one minute is reached.
Then it will display minutes and
seconds until minutes is reached.
After 60 minutes, it will display hours
now appears in display) and
minutes until the maximum time of
9 hours and
minutes is reached.
To Reset the Timer To Cancel the Timer
If “TIMER” is displayed, press the INCREASE or Press hold the TIMER ON/OFF pad the
DECREASE until desired time is reached. word “TIMER” disappears from the display.
If “TIMER” is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
set the timer.
of Cycle Tone Power Outage
The end of cycle tone is a series of three beeps After a power outage, when power is restored, the
followed by one beep every six seconds. you would display will flash and time shown will no longer be
like to remove the signal that beeps six seconds, correct-for example, after a 5-minute power
press and hold the CLEAR/OFF for seconds. interruption the clock will be 5 minutes slow.
the signal that beeps every six seconds,
The display flashes the clock is reset. All other
and hold the CLEAR/OFF pad 10 seconds.
functions that were in operation when the power went
out
have to be programmed