GE 164D2966P126 - Manual (Page 31)

to Set Oven for Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE DECREASE pad
until the desired Clean Time appears.
—
the oven is too hot and start to set
cycle, the word “OFF” appear in the display.
additional time cooling before you try
to set the
NOTE: Only one oven at time can be self-cleaned.
1. Follow the directions in the Before Clean
Cycle section.
(
AUTO SELF
CLEAN
2. closing the door, press the
AUTO SELF CLEAN pad.
3. Press the INCREASE or
DECREASE pad until the
@ \
desired Clean Time is displayed.
Clean Time is normally 3 hours.
You can change the Clean Time to
any time between 2 and 4 hours,
depending
the amount of soil
in your oven.
The self-clean cycle will automatically begin after
“CLEAN” is displayed and the time for the
is set. The words “ON” and “LOCK” will
appear in the display when the door automatically
locks. It will not be possible to open the oven door
until the temperature drops below the lock
temperature and the LOCK goes off.
4. When the LOCK light is off, open the door.
NOTE:
●
The word “clean” will be displayed, the word
“DOOR” will flash oven control will
if you set the clean and forget to close the
oven door.
●
A fan may automatically turn on and off to cool
internal parts. This is normal and the fan may
continue to run even after the oven is turned off.
1
●
You can find out when the cycle
STOP will be finished by pressing the STOP
TIME TIME pad.
To Stop a Clean Cycle
1. Press the CLEAR/OFF pad. 2. When the LOCK light goes off and the oven
CLEAR
temperature has cooled below the locking
OFF
temperature, open the door.
31