Gateway M460 - Manual (Page 108)

102 www.gateway.com
Chapter 9: Troubleshooting
You see a “Disk is full” error message
■ Delete unnecessary files on the diskette.
■ Try a different diskette. Occasionally diskettes are flawed and cannot
be read by the diskette drive.
■ Run Error checking on the diskette. If errors are detected and
corrected, try using the diskette again.
You see a “Non-system disk”, “NTLDR is missing”, or “Disk error” error
message
■ Eject the diskette from the diskette drive, then press E NTER .
■ Make sure that the diskette you are using is IBM-compatible.
The modular drive status indicator is lit continuously
■ Remove the diskette from the drive. If the indicator stays on, try
restarting your notebook.
Display
The screen is too dark
Adjust the brightness using the system keys. For more information, see
“System key combinations” on page 33 .
The screen resolution is not correct
Change the screen resolution from the Display Properties dialog box.
Tips & Tricks For instructions on running Error checking, see “Checking
the hard drive for errors” in
Using Your Computer which
has been included on your hard drive. To access this guide,
click Start, All Programs, then click Gateway
Documentation.
Tips & Tricks For instructions on changing the screen resolution, see
“Adjusting the screen resolution” in
Using Your Computer
which has been included on your hard drive. To access this
guide, click Start, All Programs, then click Gateway
Documentation.