GE Monogram ZDP48N6D - Manual (Page 8)

REMOVE PACKAGING
Runners
To Support
Leveling Legs
Panel
Range
Opening
Before moving the range indoors:
• Remove outer carton and packing material from the
shipping base.
• Remove the kick panel by removing 2 screws at the top
and pulling forward.
Kick Panel
Left Rear Shipping
Screws
The range is secured to the skid with 2 bolts in the front
and 2 “L” brackets on the bottom flange of the range
back. Remove bolts and “L” brackets.
To simplify handling and to reduce the weight of
the range:
• Remove the grates and the drawers below the knobs
(on grille and griddle models).
• Remove grill and griddle covers. DO NOT ATTEMPT
TO REMOVE A GRILL OR GRIDDLE ASSEMBLY.
• Remove the broiler pans/literature package from
inside oven(s).
Leveling Legs
Range Must
be Uniformly
Supported
on Braces
22"
Due to the weight of these ranges, use a dolly with
soft wheels to move this range.
• Lift the range onto the dolly and move indoors.
• Remove the panel from the rear of the shipping pack.
Lay the panel on the floor directly in front of the
installation location. The range should be placed
on this panel to prevent damage to the floor.
• Remove the two strips from the oven interior. Place
the strips on the floor at the left and right sides of the
installation location. These strips provide a surface
for sliding the range into the final position and will
prevent damage to the floor. The leveling legs must
rest permanently on these runner strips.
Remove oven doors:
• Fully open the door.
• Each hinge has a hinge lock. Close the hinge latch
down against the door frame.
• Firmly grasp the door at the top sides.
• Close the door to the near-vertical position.
• Lift the door up and pull straight out.
8
STEP 1
Pull the hinge locks
down to unlock.
Hinge lock
Slot
Installation