GE 28118 - Manual (Page 15)

15
Shortcut to the keylock function:
1. Make sure the phone is
OFF (not in talk mode).
. Press the menu ok/mute button, then press and hold the #pause/ringer button until
KEYPAD LOCKED shows in the display.
To unlock keypad:
Press the menu ok/mute button, then press the #pause/ringer button.
Room Monitor
(applicable only with additional handsets)
1. Make sure your phone is OFF (not in talk mode).
. Press the menu ok/mute button to go to the main menu.
3. Press vol/CID ( 6 or 5) button to scroll to
ROOM MONITOR.
4. Press the menu ok/mute button to enter ROOM MONITOR menu, ROOM MONITOR
EXTENSION? shows in the display.
5. Use the touch tone pad to enter the handset name/number to be monitored.
NOTE: When this phone system is expanded (up to 6 handsets by purchase
of optional Model 28106 handset with recharge cradle), handsets are
named HANDSET 1, HANDSET 2, HANDSET 3, and etc., respectively.
6. The receiving handset will turn on the microphone and the originating handset will turn on
the speakerphone to monitor sound from the receiving handset.
NOTE: For room monitoring mode to work, the originating handset must
NOT be on the cradle.
NOTE: While in room monitoring mode, the handsets will emit an alert
tone approximately every 5 seconds if there is an incoming call. You may
press the speaker button to quit room monitor and answer the call.
NOTE: While in room monitoring mode, the originating handset can be
switched to monitor by handset earpiece by pressing the talk button once.
Switch back to speakerphone by pressing the speaker button once.
NOTE: Press the *tone button on the handset to exit room monitor mode.