Fostex VF80 - Manual (Page 134)

134
Appendix (Installing the optional CD-RW drive)
*a blank panel
*two screws for mounting the drive
*a CD-RW drive unit
Installing the CD-1A
With the CD-1A, you can use discs of following
types.
Recordable
ReWritable
Can be used for saving or loading song
data, as well as making an audio CD.
Note that you can record data to a CD-
R disc only once. You cannot record
data to a disc which has been recorded
before.
Can be used for saving or loading song
data, as well as making an audio CD.
You can record or erase data to a CD-
R disc as many times as wish.
As these are read-only discs, you only
can use them for loading track data
to the VF80.
• When handling a disc, be careful not to dirty or
scratch the surface of the disc.
We recommend that you hold the disc with your
finger on the disc edge and center hole.
• Do not stick any paper, etc. on the label side.
Also do not scratch the label side, which may cause
problems during playback or recording. Use only a
felt pen or equivalent for writing any memo on the
label side. Using a ball-point pen, pencil, etc. that
has a hard tip may damage a disc.
• Never use a warped or chipped disc, which may
damage the CD-RW drive.
• If there is a dust, dirt or fingerprints on the disc, which
may cause error in playback or recording, wipe the
disc with a soft, dry cloth or alcohol from the center
out. Never wipe from the outside to center.
• Do not use a cleaner for analog discs or antistatic
spray, as well as volatile solvents such as benzine,
which may damage the disc surface.
• Do not expose any disc to direct sunlight, or leave it
in hot, moist or cold places.
• Read the attached manual packed with the disc be
fore using it.
The CD-1A package includes the drive and accessories shown below.
After purchasing the unit, check that all items are included. When installing the CD-1A to the VF80, the blank
panel and two screws are not used.