Fostex VF80 - Manual (Page 119)

119
Save/Load of Song data
Warning!
You are responsible for use of this digital de-
vice. Be sure to abide by the copyright condi-
tions of the source material.
Press “Enter/Yes” key if you agree with the
above.
If you agree to the message contents, press the
[ENTER/YES] key.
After showing “Set Enable!” , the display shows the
screen for selecting the song(s) to be loaded.
If there is more than one track recorded on the au-
dio CD, “ ” flashes, showing that you can select a
desired track. If there is only one track recorded on
the audio CD. “ ” is not shown on the screen.
Use the [JOG] dial to select a track number to be
loaded and press the [ENTER/YES] key.
The destination program number starts flashing,
which is one greater than the highest program num-
ber among those available on the current drive.
This means a track is going to be loaded to a new
program.
For example, if there are 4 programs available on
the current drive, the destination program number(s)
on the current drive and then perform step 7 above
again. If there are already 99 programs on the cur-
rent drive,
“Disk Full!” appears and no destination
program number is shown. In such a case, delete
the unnecessary program(s) on the current drive and
then perform step 7 above again.
To load more than one track, repeat steps 7 through
8 above.
The following screen example shows that tracks 1
and 2 will be loaded to program 05 and 06 respec-
tively. The track time is also shown to the left of
each program number.
The warning message above also appears when
setting the “
Digital In setting ” menu to “ On ”.
See “ Setup mode ” on page 130 for details.
Flashing
When loading from a audio CD, no title is shown
when selecting the track.
If you do not agree with the warning message con-
tents, press the
[EXIT/NO] key to quit loading.
The display briefly shows “Set Disable” and “ Can’t
Loading” , then returns to the mode select screen.
If you agree with the warning message contents,
go to the next step to continue the operation. By rotating the [JOG] dial, you can select “NON” , as
well as a “Program” . When performing the load op-
eration, tracks that are set to “NON” are not loaded.
While the program number is flashing, press the
[ENTER/YES] key.
The flashing program number changes to light sol-
idly, showing that the first track is ready to be loaded
to the program.
6
7
8
or
The warning message for copyright shown on the
screen is as follows.