Fortinet FortiGate 5020 - Manual (Page 5)

FortiGate-5020 chassis FortiGate-5020 front panel
FortiGate-5020 Chassis Guide
01-30000-0043-20061207
5
FortiGate-5020 chassis
You can install one or two FortiGate-5000 series modules in the two slots of the
FortiGate-5020 ATCA chassis. The FortiGate-5020 is a 4U chassis that contains
two redundant AC to DC power supplies that connect to AC power. The
FortiGate-5020 chassis also includes an internal cooling fan tray. If both slots
contain FortiGate-5001SX modules, the FortiGate-5020 chassis provides a total
of 16 Gigabit ethernet FortiGate interfaces.
If you install the same FortiGate-5000 series module in both slots, you can
configure the modules to operate as an HA cluster. HA heartbeat communications
between the modules uses the FortiGate-5020 backplane. No extra switching or
other connections are required.
The FortiGate-5020 chassis can only be connected to AC power. Two redundant
FortiGate-5020/5050 power supplies are factory installed in the FortiGate-5020
chassis.
FortiGate-5020 front panel
Figure 1 shows the front of a FortiGate-5020 chassis. Two FortiGate-5002FB2
modules are installed. The FortiGate-5020/5050 power supplies are factory
installed behind the panel at the top of the chassis. The power LEDs for the power
supplies are visible on the front panel as well.
Figure 1: FortiGate-5020 front panel with two FortiGate-5002FB2 modules
PSU A
PSU B
PWR IPM
USB 5 3 4 5 6 CONSOLE
STATUS
1 6 2
ALT
ON/OFF RESET
PWR IPM
USB 5 3 4 5 6 CONSOLE
STATUS
1 6 2
ALT
ON/OFF RESET
Hot-swappable FortiGate-5020/5050
power supplies (behind panel)
Power LEDs
PSU A PSU B
FortiGate-5002FB2
modules
Hot swappable cooling fan tray
(accessable from back panel)
!
Caution: Do not operate the FortiGate-5020 chassis with open slots on the front panel. For
optimum cooling performance and safety, the slots must contain a FortiGate-5000 series
module or an air baffle slot filler.