Fujitsu Siemens Computers 19T2 - Manual (Page 28)

Color monitor 19T2
20 - English A26361-K616-Z100-2-5E19
Two fine horizontal lines (wires) are visible
i
Your monitor is equipped with a Trinitron picture tube, which enables more light to reach
the screen with a vertical slot mask, and therefore produces more intense colors. The
thin lines visible with a white background are shadows of the damper wires, which
stabilize the vertical slot mask. They are characteristic of picture tubes with a vertical slot
mask. There is no malfunction.
The screen display is too small or not centered
The monitor recognizes an undefined mode (see " Technical data ").
i
To display the current mode (horizontal frequency and refresh rate), press the or
buttons.
Ê Press the picture size/position button to automatically adjust the screen display.
Ê Correctly adjust the picture size and position with the OSD menu (see " Operation of the
monitor ", section "Setting picture position and size (SIZE/CENTER)").
Picture geometry is defective
Ê Correctly adjust the picture geometry with the OSD menu (see " Operation of the monitor ",
section "Setting picture geometry (GEOMETRY)").
Colors are impure or shifted
Ê Degauss the monitor (see " Operation of the monitor ", section "Setting monitor options
(OPTION)").
Ê Set the convergence (see " Operation of the monitor ", section "Setting convergence
(CONVERGENCE)").
White does not look white
Ê Set the color temperature (see " Operation of the monitor ", section "Setting color temperature
and colors (COLOR)").
Screen display has lines, is dull or blurred
Ê Set the brightness and contrast (see " Operation of the monitor ").
Ê Degauss the monitor (see " Operation of the monitor ", section "Setting monitor options
(OPTION)").
Ê Set the convergence and reduce the Moiré correction (see " Operation of the monitor ", section
"Setting monitor options (OPTION)").
The screen display is flickering
Ê Set an ergonomic refresh rate (
≥
75 Hz) using the PC software (see documentation for your PC
or your screen controller/graphics card).
Monitor adjustment buttons do not react
The buttons have probably been locked with the OSD menu.
Ê Unlock the monitor adjustment buttons (see " Operation of the monitor ", section "Setting monitor
options (OPTION)").