Follett 400 Series - Manual (Page 6)

Installation
1. Install Cornelius ice dispenser according to
manufacturer’s specifications.
Note: We recommend that the dispenser
back be mounted at least 1" (26mm) from wall to
allow water, drain and electric lines from top-mount
icemakers to be concealed behind dispenser.
2. Disconnect power to dispenser.
3. Remove front panel/merchandiser from the dispenser.
4. Adjust the agitation timer located on Cornelius PC
board to 1 second on – 1 hour off (Fig. 1).
Fig. 1
5. Install supplied
nugget ice diverter at
dispenser opening.
a) Disassemble
chute assembly
and discard gate
restrictor (Fig. 2.1).
b) Reassemble with
supplied ice
diverter as shown
(Fig. 2.2).
6. Reinstall front panel.
ON
OFF
agitation
timer
Fig. 2
storage hopper
gate
restrictor
plate
flange extends
into storage
hopper through
gate opening
apply RTV to this
surface to seal to
hopper gate
mounting plate
gasket
flat washer
10-32 nut
ice chute
ice diverter
(supplied)
gate
mounting
plate
1
2
6